CC - Staff Report
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 1
STAFF REPORT
MEETING DATE: July 18, 2017
TO: Mayor and City Council
FROM: Josh Beach, Associate City Planner
208-884-5533
Bruce Freckleton, Development Services Manager
208-887-2211
SUBJECT: Brinegar Prairie Subdivision No. 2 – FP (H-2017-0094)
I. APPLICATION SUMMARY
The applicant, Challenger Development, LLC, has applied for final plat (FP) approval of 48 single-
family residential building lots and 8 common lots on 10.71 acres of land in an R-8 (medium-density
residential) zoning district, for Brinegar Prairie Subdivision No. 2.
II. STAFF RECOMMENDATION
Staff recommends approval of the Brinegar Prairie Subdivision No. 2 final plat subject to the
conditions noted in Sections VI and VII below. These conditions shall be considered in full, unless
expressly modified or deleted by motion of the City Council.
III. PROPOSED MOTION
Approval
I move to approve File Number H-2017-0094 as presented in the staff report for the hearing date of
July 18, 2017, with the following modifications: (Add any proposed modifications.)
Denial
I move to deny File Number H-2017-0094, as presented during the hearing on July 18, 2017, for the
following reasons: (You should state specific reasons for denial.)
Continuance
I move to continue File Number H-2017-0094 to the hearing date of (insert continued hearing date
here) for the following reason(s): (You should state specific reason(s) for continuance.)
IV. APPLICATION AND PROPERTY FACTS
A. Site Address/Location:
The site is located at 2220 N. Ten Mile Road on the east side of N. Ten Mile Road, north of W.
Cherry Lane, in the SW ¼ of Section 02, Township 3N., Range 1W.
B. Applicant:
Challenger Development, Inc.
9839 W. Cable Car St. Ste. 101
Boise, ID 83709
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 2
C. Owner:
Heartland Townhomes Property Management
9839 W. Cable Car St. Ste. 101
Boise, ID 83709
D. Agent:
Kent Brown, Kent Brown Planning
3161 E. Springwood Drive
Meridian, ID 83642
V. STAFF ANALYSIS
The proposed final plat depicts 48 single-family residential building lots and 8 common lots on 10.71
acres of land in an R-8 zoning district. . The gross density is 4.48 dwelling units (d.u.) per acre with a
net density of 6.56. The minimum lot size is 5,750, and the average lot size is 6,776 square feet. All
of the lots proposed in this phase are for single-family detached homes and must comply with the
dimensional standards of the R-8 zoning district listed in UDC Table 11-2A-6. Staff has reviewed the
proposed plat and found it in compliance with the aforementioned dimensional standards.
The proposed common open space for the subdivision consists of the drainage lot and pond on Lot
56, Block 1 and an additional common lot with a micropath on Lot 32, Block 1. The proposed
common open space and site amenities comply with the overall common open space and site
amenities approved with the Brinegar Prairie Subdivision.
Staff has reviewed the proposed final plat for substantial compliance with the approved preliminary
plat in accord with the requirements listed in UDC 11-6B-3C.2.
The number of buildable lots and common area is the same as shown on the approved preliminary
plat; therefore, staff finds the proposed final plat in substantial compliance with the approved
preliminary plat.
VI. SITE SPECIFIC CONDITIONS
1. The applicant shall comply with all applicable conditions of approval associated with this site (H-
2015-0046 and recorded development agreement instrument #2016-037778).
2.
3. The applicant has until May 24, 2019, to obtain City Engineer’s signature on the final plat or
apply for a time extension in accord with UDC 11-6B-7.
4. Prior to submittal for the City Engineer’s signature, have the Certificate of Owners and the
accompanying acknowledgement signed and notarized.
5. The applicant shall provide details of the drainage ponds prior to signature on the final plat.
6. The final plat prepared by Bailey Engineering, Inc., dated 07/12/17, prepared by Gregory G.
Carter, shall be revised as follows:
a. Include the applicable recorded instrument numbers in note #10.
b. Include the applicable recorded instrument numbers in note #13.
7. The applicant shall comply with the submitted landscape plan prepared by Jensen Belt., dated
06/06/17.
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 3
8. Prior to signature of the final plat by the City Engineer, the applicant shall provide a letter from
the United States Postal Service stating that the applicant has received approval for the location of
mailboxes. Contact the Meridian Postmaster, Sue Prescott, at 887-1620 for more information.
9. Staff’s failure to cite specific ordinance provisions or conditions from the preliminary plat does
not relieve the applicant of responsibility for compliance.
10. Prior to the issuance of any new building permits, the property shall be subdivided in accordance
with the UDC.
11. The applicant shall construct homes within the proposed development consistent with the
elevations approved with the recorded development agreement
12. The homes proposed for Lots 6-9 and 20 of Block 2 shall receive planning approval prior to the
issuance of building permits.
12. Prior to City Engineer’s signature on the final plat, the applicant shall submit a final approval
letter from the Street Naming Committee approving the street names for the proposed
subdivision.
13. The streetlight plan that was submitted with the development plans does not meet the required
spacing of 260' along internal roads. Streetlights should be spaced evenly along W. Chateau
Drive. Plan should include City of Meridian standard Street Light Plan Notes found at
http://www.meridiancity.org/city_departments.aspx?id=272.
14. The dead end water main in N. Morello Court shall terminate with a fire hydrant.
VII. GENERAL REQUIREMENTS
1. Sanitary sewer service to this development is available via extension of existing mains adjacent to
the development. The applicant shall install mains to and through this subdivision; applicant shall
coordinate main size and routing with the Public Works Department, and execute standard forms
of easements for any mains that are required to provide service. Minimum cover over sewer
mains is three feet, if cover from top of pipe to sub-grade is less than three feet than alternate
materials shall be used in conformance of City of Meridian Public Works Departments Standard
Specifications.
2. Water service to this site is available via extension of existing mains adjacent to the development.
The applicant shall be responsible to install water mains to and through this development,
coordinate main size and routing with Public Works.
3. Street signs are to be in place, sanitary sewer and water system shall be approved and activated,
fencing installed, drainage lots constructed, road base approved by the Ada County Highway
District (ACHD) and the Final Plat for this subdivision shall be recorded, prior to applying for
building permits.
4. Upon installation of the landscaping and prior to inspection by Planning Department staff, the
applicant shall provide a written certificate of completion as set forth in UDC 11-3B-14A.
5. A letter of credit or cash surety in the amount of 110% will be required for all incomplete
fencing, landscaping, amenities, pressurized irrigation, prior to signature on the final plat.
6. The City of Meridian requires that the owner post with the City a performance surety in the
amount of 125% of the total construction cost for all incomplete sewer, water infrastructure prior
to final plat signature. This surety will be verified by a line item cost estimate provided by the
owner to the City. The applicant shall be required to enter into a Development Surety Agreement
with the City of Meridian. The surety can be posted in the form of an irrevocable letter of credit,
cash deposit or bond. Applicant must file an application for surety, which can be found on the
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 4
Community Development Department website. Please contact Land Development Service for
more information at 887-2211.
7. The City of Meridian requires that the owner post to the City a warranty surety in the amount of
20% of the total construction cost for all completed sewer, and water infrastructure for a duration
of two years. This surety amount will be verified by a line item final cost invoicing provided by
the owner to the City. The surety can be posted in the form of an irrevocable letter of credit, cash
deposit or bond. Applicant must file an application for surety, which can be found on the
Community Development Department website. Please contact Land Development Service for
more information at 887-2211.
8. All development improvements, including but not limited to sewer, water, fencing, pressurized
irrigation and landscaping shall be installed and approved prior to obtaining certificates of
occupancy, or as otherwise allowed by UDC 11-5C-1.
9. Applicant shall be required to pay Public Works development plan review, and construction
inspection fees, as determined during the plan review process, prior to the issuance of a plan
approval letter.
10. It shall be the responsibility of the applicant to ensure that all development features comply with
the Americans with Disabilities Act and the Fair Housing Act.
11. Applicant shall be responsible for application and compliance with any Section 404 Permitting
that may be required by the Army Corps of Engineers.
12. Developer shall coordinate mailbox locations with the Meridian Post Office.
13. All grading of the site shall be performed in conformance with MCC 11-1-4B.
14. Compaction test results shall be submitted to the Meridian Building Department for all building
pads receiving engineered backfill, where footing would sit atop fill material.
15. The engineer shall be required to certify that the street centerline elevations are set a minimum of
3-feet above the highest established peak groundwater elevation. This is to ensure that the bottom
elevation of the crawl spaces of homes is at least 1-foot above.
16. The applicants design engineer shall be responsible for inspection of all irrigation and/or
drainage facility within this project that do not fall under the jurisdiction of an irrigation district
or ACHD. The design engineer shall provide certification that the facilities have been installed in
accordance with the approved design plans. This certification will be required before a certificate
of occupancy is issued for any structures within the project.
17. At the completion of the project, the applicant shall be responsible to submit record drawings per
the City of Meridian AutoCAD standards. These record drawings must be received and approved
prior to the issuance of a certification of occupancy for any structures within the project.
18. 100 Watt and 250 Watt, high-pressure sodium street lights shall be required on all public
roadways per the City of Meridian Improvement Standards for Street Lighting. All street lights
shall be installed at developer’s expense. Final design shall be submitted as part of the
development plan set for approval, which must include the location of any existing street lights.
Street lighting is required at intersections, corners, cul-de-sacs, and at a spacing that does not
exceed that outlined in the Standards. The contractor’s work and materials shall conform to the
ISPWC and the City of Meridian Supplemental Specifications to the ISPWC. Contact the City of
Meridian Transportation and Utility Coordinator at 898-5500 for information on the locations of
existing street lighting.
19. The applicant shall provide easement(s) for all public water/sewer mains outside of public right of
way (include all water services and hydrants). The easement widths shall be 20-feet wide for a
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 5
single utility, or 30-feet wide for two. The easements shall not be dedicated via the plat, but
rather dedicated outside the plat process using the City of Meridian’s standard forms. The
easement shall be graphically depicted on the plat for reference purposes. Submit an executed
easement (on the form available from Public Works), a legal description prepared by an Idaho
Licensed Professional Land Surveyor, which must include the area of the easement (marked
EXHIBIT A) and an 81/2” x 11” map with bearings and distances (marked EXHIBIT B) for
review. Both exhibits must be sealed, signed and dated by a Professional Land Surveyor. DO
NOT RECORD. Add a note to the plat referencing this document. All easements must be
submitted, reviewed, and approved prior to development plan approval.
20. Applicant shall be responsible for application and compliance with and NPDES permitting that
may be required by the Environmental Protection Agency.
21. Any existing domestic well system within this project shall be removed from domestic service per
City Ordinance Section 9-1-4 and 9 4 8 contact the City of Meridian Engineering Department at
(208)898-5500 for inspections of disconnection of services. Wells may be used for non-domestic
purposes such as landscape irrigation if approved by Idaho Department of Water Resources
Contact Robert B. Whitney at (208)334-2190.
22. Any existing septic systems within this project shall be removed from service per City Ordinance
Section 9-1-4 and 9 4 8. Contact Central District Health for abandonment procedures and
inspections (208)375-5211.
23. The City of Meridian requires that pressurized irrigation systems be supplied by a year-round
source of water (MCC 9-1-28.C.1). The applicant should be required to use any existing surface
or well water for the primary source. If a surface or well source is not available, a single -point
connection to the culinary water system shall be required. If a single-point connection is utilized,
the developer will be responsible for the payment of assessments for the common areas prior to
development plan approval.
24. All irrigation ditches, canals, laterals, or drains, exclusive of natural waterways, intersecting,
crossing or laying adjacent and contiguous to the area being subdivided shall be tiled per UDC
11-3A-6. In performing such work, the applicant shall comply with Idaho Code 42-1207 and any
other applicable law or regulation.
V. EXHIIBITS
A. Vicinity Map
B. Approved Preliminary Plat (dated: 12/23/15)
C. Proposed Final Plat (dated: 07/12/17)
D. Proposed Landscape Plan (dated: 06/06/17)
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 6
Exhibit A – Vicinity Map
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 7
Exhibit B – Approved Preliminary Plat (dated: 12/23/15)
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 8
Exhibit C – Proposed Final Plat (dated: 07/12/17)
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 9
Exhibit D – Proposed Landscape Plan (dated: 06/06/2017)
Brinegar Prairie Subdivision No. 2– FP (H-2017-0094) PAGE 10