HomeMy WebLinkAbout8 - Landscape Plan V1(V
O
Egress to existing Bridge to City of
Meridian pathway
1 " = 20'-0"
2"x4" Top and Bottom
1 "x6" Rough Sawn
4"x4" PT. Spruce Post
io
4"x4" PT Post
Rough Sawn Spruce Stained
w/ "Sandstone" Solid Wood
Stain By Cloverdale Paints.
Fence Boards To Be Close
Nailed. Space Dia. Of one
Nail 1 "x6" Sas Spruce.
1' Dia Conc. Base
Note:
1. All wood to be stained with "Sandstone" solid wood stain both sides prior to installation.
2. All hardware to be galvanized.
3. All stain to be applied to manufacturer's specifications.
5. Nail to be 3 1/2" coated for stringers to posts and 2" ardox for boards.
7. All planed materials #2 and better.
Fence Detail
1 /4" = 1'-0"
Street Lighting
1. All street light construction shall be don in accordance with the current version of
the ISPWC, the Meridian Supplemental Specifications to the ISPWC, and the
National Electric Code.
2. A street lighting electrical permit shall be openend prior to starting work. Use the
online Citizen portal at HTTP://citizenportal.meridiancity.org/CitizenAccess/ to
open a permit and request inspections.
3. Installation will require inspections for the concrete bases and below ground
wiring.
4. Street lift bases shall be located 10' minum from tree, 5minimum from fire
hydrants and 2' minimums from water meters.
5. Keep accurate asbuilts of all conduit, Junction boxes, and submit an electronic
copy of the red line as -build with the approved permit to the city of Meridian at
compleation of project.
6. Coordinat with the City transportation and Utility Coordinator @ (208) 898-5500
for questions regarding Utility conflicts, or access locked meter pedestals.
LIGHTING NOTE
1 " = 1'-0"
SOIL LINE —
ROOT PROBE
WHEN PRESENT: LOCATE THE
BUD POINT 1 1/2" ABOVE SOIL
LINE
N
ROOT LOCATE FLARE/ COLLAR
2
@ SOIL LINE. THIS CAN BE
iv
LOCATED BY SWELLING LINE,
WERE THE BARK OF THE TREE
TRANSITIONS TO ROOT BARK)
HIGHEST ROOT SHALL BE 2"
MAXIMUM BELOW SOIL LINE. UTILIZE
SOIL/ ROOT PROBE AROUND TRUNK
(APPROX 1-2" AWAY FROM TRUNK)
TO LOCATE HIGHEST ROOT.
RUBBER CINCH TIE
2"X2" WOOD STAKE AT OR BELOW
GRADE PLACE STAKES PARALLEL
TO PREVAILING WIND.
REMOVE TREE WRAP AFTER
INSTILATION.
3" THICK MULCH 3" FROM TREE
TRUNK.
CONSTRUCT 2" EARTH BERM
AT EDGE OF ROOTBALL,
REMOVE BURLAP, TWINE, AND
WIRE BASKET FROM TOP 2/3" OF
ROOTBALL, REMOVE ALL
NONBIODEGRADABLE TRASH
FROM HOLE.
ROOTBALL TO BE PLACED
ON NATIVE SOIL.
COMMERCIAL SLOW RELEASE
FERTILIZER TABLETS
BACKFILL W/ APPROVED TOPSOIL.
BACK FILL IN 6" LIFTS, WATERING
EACH LAYERAND TAMP AS
REQUIERD TO SUPPORT TREE. —
WIDTH OF BALL I WIDTH OF BALL
WIDTH OF BALL
5' MIN DIA. TREE RING
Keynote Legend
OTage Keynote Text
6'-0" Ceeder fencing, see detail 5/1_1
1 6'-0" Ceeder fencing, see detail 5/1_1
2 Street Lamp are to be type 2 per meridian standard drawing T1 & T2.
Install street lights are to be installed per current city of Meridian
supplemental specifications.
NOTES: TREE PLANTING (>2"CAL
1. ALL PLANT MATERIALS SHALL BE IN ACCORDANCE WITH
THE AMERICAN STANDARDS FOR NURSERY STOCK (ANSI
Z60.1-2004). PLANT ACCORDING TO ANSI A300 PART 6.
2. DIG THE PLANTING HOLE A MINIMUM OF 2x WIDTH OF
ROOTBALL FOR AT LEAST THE FIRST 12 INCHES OF DEPTH.
BELOW 12 INCHES, DIG HOLE WIDE ENOUGH TO PERMIT
ADJUSTING. DO NOT DIG THE HOLE DEEPER THAN ROOT BALL
DEPTH.
3. SCARIFY THE SUBGRADE AND SIDES OF THE PLANTING
HOLE WHEN PLANTING IN CLAY SOILS (MORE THAN 15%
CLAY).
4. LIFT AND SET THE TREE BY ROOT BALL ONLY. DO NOT LIFT
USING THE TREE TRUNK AND DO NOT USE TREE TRUNK AS A
LEVER.
5. SET THE TOP OF THE ROOT BALL LEVEL WITH THE SOIL
SURFACE OR SLIGHTLY HIGHER IF THE SOIL IS PRONE TO
SETTLING.
6. AFTER THE TREE IS SET IN PLACE, REMOVE BURLAP, WIRE
AND STRAPS FROM AT LEAST THE UPPER 1/3 OF THE
ROOTBALL.
7. BACKFILL WITH EXISTING SOIL THAT HAS BEEN WELL -
TILLED OR BROKEN UP. DO NOT ADD AMENDMENTS TO THE
BACKFILL SOIL. AMEND THE SURFACE WITH MULCH.
8. USE THREE 2" X 2" WOOD STAKES DRIVEN INTO
UNDISTURBED SOIL A MINIMUM OF 16INCHES. SPACE STAKES
EQUALLY AROUND THE TREE.
9. ATTACH 3/4" NYLON WEBBING TO CONNECT THE TREE TO
2" settled layer
STAKES. ATTACH WEBBING AT 1/3 THE TREE HEIGHT.
of mulch
10. APPLY A 2-3" (SETTLED) DEPTH OF PINE STRAW OR BARK
MULCH TO THE PLANTING SURFACE. LEAVE A 2" SPACE
Tilled Or Broken up
AROUND THE TRUNK FOR AIR CIRCULATION.
Soil min 12" Deep
11. PRUNING SHALL BE LIMITED TO DEAD, DISEASED, OR
BROKEN LIMBS ONLY AND SHALL BE IN ACCORDANCE WITH
ANSI A300 SPECIFICATIONS.
12. REMOVE ANY TRUNK WRAP REMAINING AT TIME OF
PLANTING. NO WRAPS SHALL BE PLACED ON TRUNK.
FINISH GRADE
WIDTH OF BALL I WIDTH OF BALL
n 2" and larger conifer tree detail
J 3/16" = 1'-0"
1710 E. Summerridge
Meridian Idaho 83646
0:208-895-0437
Plabsl7@gmail.com
Hesscomm Corp.
2338 w. Boulder Bar Drive
Meridian, Idaho 83646
ph. 208-7894064
Date
Hesscomm Corp.
Pinedale Subdivision
Landscape Plan
3679 W Newland St.
Project number BH-21-02
Date 8-3-21
Drawn by Author
Checked by Checker
L1
Scale As indicated