HomeMy WebLinkAboutBienville Square No. 3SUBDIVISION RESTRICTION FORM
Bienville Square Subdivision No.3 Planner: Bill Parsons
Dimensional Standards:
R-15 Standards
Requirement
Rear setback (ft.)
12’
Interior
side setback (ft.) (In some cases, there may be a greater setback due to a wider utility easement - refer to the recorded plat for specific easement information.)
5’
Street setback1
to garage (ft.)
Local
20’
Street setback1 to living area (ft.)
Local
10’
Maximum building height (ft.) (as defined by the Building Code)
40’
Note:
1Measured from back of sidewalk or property line where there is no adjacent sidewalk.
Parking Standards for Dwellings [single-family detached and attached]:
Number of Bedrooms
(per unit)
Required Parking Spaces1
1
2 per dwelling unit; at least 1 in an enclosed garage, other space may be enclosed or a minimum 10’ x 20’ parking pad2
2/3/4
4 per dwelling
unit; at least 2 in an enclosed garage, other spaces may be enclosed or a minimum 10’ x 20’ parking pad2
5+
6 per dwelling unit; at least 3 in an enclosed garage, other spaces may
be enclosed or a minimum 10’ x 20’ parking pad2
Notes:
1The size of the garage or carport required for dwelling units shall be measured by exterior dimensions & shall be at
least 10’ x 20’ for a 1 space garage or carport and 20’ x 20’ for a 2 space garage or carport.
2The parking pad shall be measured from the edge of sidewalk or edge of paved travel lane
(public street, private street, or alley) where no sidewalk exists.
Fencing (UDC 11-3A-7): All proposed fencing in residential districts shall comply with the following:
Maximum
fence height allowed
6’
Front yard
3’ solid or 4’ open vision fencing
Street side yard
3’ solid or 4’ open vision fence at the property line or 6’ fence set back 10’ from property
line
Rear yard
6’ (unless adjacent to interior common area or pathway – see below)
Fencing adjacent to interior common lot or pathway (side or rear)
4’ solid or 6’ open vision
fence (6’ solid is prohibited)
Special Requirements: Per the recorded development agreement, the applicant must obtain CZC and DES approval from the Planning Division prior to applying
for a building permit.